BP7306 Nottingham 6/19/06 1:00 PM Page 6
BLADE FLANGE
5/32 x 9/16"
PAN HEAD SCREWS (2)
MOUNTING 
HUB
4. Remove and retain four pan head screws from the rim of the switch cup adapter (Figure 3).
5. Position the switch cup assembly on the switch cup adapter. Line up the four holes in the switch cup with the threaded holes in the switch cup adapter and reinstall four pan head screws (previously removed) (Figure 4).
CAUTION: Before installing and tightening the screws, be sure there are no wires pinched between the switch cup adapter and switch cup assembly.
Figure 2
3. Carefully rest the switch cup assembly on the fan blades, then engage the connector of the switch cup assembly with the motor connector (Figure 3). The two connectors are keyed and must be mated correctly before they can be engaged. Make sure the connectors are engaged properly.
SWITCH CUP
ASSEMBLY
Figure 4
SWITCH CUP
ASSEMBLY
REINSTALL FOUR
PAN HEAD SCREWS
CONNECTORS
REMOVE AND RETAIN FOUR PAN HEAD SCREWS
Figure 3
SWITCH CUP ADAPTER
6. Carefully place the partially assembled ceiling fan on the lower styrofoam pad, with the switch cup assembly positioned in the opening and the blade assemblies resting on the outer rim of the styrofoam pad.
7. Remove the hanger ball by loosening the setscrew in the hanger ball until the ball falls freely down the downrod (Figure 5). Remove th pin from the downrod, then remove the hanger ball. Retain the pin and hanger ball for reinstallation in step 19.
6
