Emerson CF4600WB00 Downrod Upper, Housing/Glass Setscrew Lower Housing Flange, Trim, Upper Glass

BP7306 Nottingham 6/19/06 1:00 PM Page 8

KNURLED

KNOB (2)

LOCKWASHER (2)

COUPLING

COVER

1" THREADED STUD (2)

7-WATT (MAXIMUM)

CANDELABRA BULB (6)

MOTOR

COUPLING

SOCKET

14. Carefully place the upper housing over the upper glass, making certain that the upper glass seats firmly in the upper housing flange.

15. Align the two holes in the housing trim with two threaded holes in the upper housing (Figure 8). Loosely install two 8-32 x 1/2” pan head screws (supplied) to secure the trim. Repeat this procedure for the remaining two housing trims.

16. Made sure the upper housing is still seated evenly on the upper glass. Then alternately tighten the screws securing the housing trim one-half turn until the screws are tight.

Figure 7

NOTE: Lightly snug the knurled knobs and make sure the wires and wire connectors are completely inside the coupling cover and not pinched between the coupling cover and the motor.

12. Install six 7-watt (maximum) candelabra bulbs (not supplied) in the sockets on the motor housing (Figure 7).

13. Place the upper glass on a padded work surface with the larger opening towards the top (Figure 8).

17.Thread the three motor wires through the hole in the upper housing. Then slide the upper housing/glass over the downrod until the glass seats evenly in the lower housing flange (Figure 9). After the glass is properly seated, tighten the setscrew in the upper housing.

CAUTION: Be sure there are no wires pinched between the glass and the lower housing flange.

DOWNROD

UPPER

8-32 x 1/2" PAN HEAD SCREW (2)

UPPER HOUSING

HOUSING/GLASS

SETSCREW

LOWER

HOUSING

FLANGE

HOUSING
TRIM	Figure 9
UPPER GLASS

Figure 8

8