Empire Comfort Systems DVP42FP, P)-2 installation instructions LOG PLACEMENT 4 LOG SET, Figure

LOG PLACEMENT (4 LOG SET)

Before you begin: If you are installing logs into the DVP42 or DVP48 model then this fireplace is supplied with a set of three ceramic fiber logs. Do not handle these logs with your bare hands. Always wear gloves to prevent skin irritation from ceramic fibers. After handling logs, wash your hands gently with soap and water to remove any traces of fiber.

The positioning of logs is critical to safe and clean operation of this fireplace. Sooting and other problems may result if the logs are not properly and firmly positioned in the fireplace. Please refer to Figure 77, Figure 78, and Figure 79 and corresponding WARNING, when completing the following log placement steps.

1.Remove top louver, grasp louver, lift and pull forward.

2.Lower bottom louver, lift and hinge forward.

3.Release two glass frame spring clamps at bottom of firebox

4.Place rear (#1) log onto two (2) pins on rear log support.

5.Place left, front (#2) log onto two (2) left, front pins on burner pan.

6.Place right, front (#3) log onto two (2) right, front pins on burner pan.

7.Place Branch (#4) onto one (1) pin on rear log

8.Place decorative rock in front of grates and sides of main burner.

ATTENTION: Do not place decorative rock on logs or on burner. The decorative rock should only be placed on the fireplace floor.

9.After all logs are properly positioned, place small "dime" size pieces of Rockwool lightly across the front round "blueflame" ports. Place the ember material (Rockwool pieces) side by side. Do not stack more than one layer of embers across the burner ports. See Figure 77.

10.Replace glass door onto firebox.

11.Secure the two glass frame spring clamps at bottom of firebox.

12.Align the tabs on top louver brackets with slots in front posts to secure top louver.

13.Close bottom louver. Lift slightly to engage the end tabs into the slots in fireplace sides to close louver panel.

REAR LOG LOCATOR TABS

Figure 77

EMBER PLACEMENT

BOTTOM LOG LOCATOR PINS

21759-6-0608

Figure 78

WARNING: Failure to position the parts in accordance with this diagram or failure to use only parts specifically approved with this appliance may result in property damage or personal injury.

Attention: Do not use Figure 78 or Figure 79 to order logs. Refer to parts view on page 63 and parts list on pages 64 and 65 to order logs and/or ember material for your appropriate fireplace model.

#4 - TOP BRANCH

#1 - REAR LOG

#3 - FRONT

#2 - FRONT RIGHT LOG LEFT LOG

Figure 79

Page 45