The HBAnyware Utility User Manual Page 34
Viewing Target Mapping (Windows, Solaris LPFC and Solaris SFS)
The Target Mapping tab enables you to view current target mapping and to set up persistent binding.
To view target mapping:
1. Select Host or Fabric sort.
2. Select the HBA in the discovery-tree whose target mapping information you wish to view.
3. Select the Target Mapping tab.
Figure 23: Target Mapping tab
Target Mapping Field Definitions
Current Settings Area
• Active Bind Type - WWPN, WWNN, or a destination identifier (D_ID).
• Automapping - The current state of SCSI device automapping: enabled (default) or disabled.
Current Mappings Area
• This table lists current mapping information for the selected HBA.
Persistent Binding Configuration Area
• This table lists persistent binding information for the selected HBA.
Display Mode Radio Buttons
• Show WWPN, Show WWNN or Show D_ID.
Target Mapping Buttons
• Refresh - Click to refresh the Target Mapping tab.
• Change Settings - Click to change the active bind type (the mode used to persistently bind target
mappings), LUN automapping or LUN unmasking settings. The Mapped Target Setting window
is displayed. Select the active bind type (WWPN, WWNN, D_ID or AL_PA), set LUN
automapping to enabled or disabled, and/or set LUN unmasking to enabled or disabled.
• Add Binding - Click to add a persistent binding.
• Bind New - Click to add a target that does not appear in the Persistent Binding table.
• Remove - Click to remove the selected binding.
• Remove All - Click to remove all persistent bindings that are displayed.