The HBAnyware Utility User Manual Page 48
CoalesceRspCnt=n This parameter specifies the number of response entries that trigger
an Interrupt response.
Value: 0 - 255 (decimal) or 0x1 - 0xFF (hex)
Default = 8 (0x8)
Restart
DiscoveryDelay=n DiscoveryDelay controls whether the driver waits for ‘n’ seconds to
start port discovery after link up.
If set to 0 = immediate discovery after link up.
If set to 1 or 2 = the number of seconds to wait after link-up before
starting port discovery.
Value: 0 - 2 seconds (decimal)
Default = 0.
Dynamic
EnableAck0=n EnableAck0 set to 1 to force sequence rather than frame level
acknowledgement for class 2 traffic over an exchange. This applies to
FCP data exchanges on IREAD and IWRITE commands.
Value: 0 - 1 (decimal)
Default = 0
Restart
EnableAUTH This parameter enables fabric authentication. This feature requires
the authentication to be supported by the fabric. Authentication is
enabled when this value is set to 1.
Value: 0 - 1
Default = 0
Reboot
EnableFDMI=n If se t to 1, e nables mana gement server logi n on fabric discovery. This
allows Fabric-Device Management Interface (FDMI) to operate on
switches that have FDMI-capable firmware.
If set to 2, FDMI operates and uses the host name feature of FDMI.
Value: 0 -2 (decimal)
Default = 0
Restart
EnableNPIV=nIf set to 1, enables N_Port_ID virtualization (NPIV). Requires NPIV
supported firmware and HBA.
Value: 0 -1
Default = 0 (disabled)
Note: To run the driver using NPIV or SLI-3 optimization, the firmware
must be version 2.72a0 or later. If an earlier version is used, the driver
will run in SLI-2 mode and will not support NPIV..
Restart
Table 1: Storport Miniport Driver Parameters (Continued)
Parameter Definition s Activation
Requirement