The HBAnyware Utility User Manual Page 49
FrameSizeMSB=n FrameSizeMSB controls the upper byte of receive FrameSize if
issued in PLOGI. This allows the FrameSize to be constrained on
256-byte increments from 256 (1) to 2048 (8).
Value: 0 - 8
Default = 0
Restart
HardALPA=0xn HardALPA allows the HBA to use a hard assigned loop address.
Value: 0x00 - 0xEF (hex)
Default = 0x00 (use soft addressing, or flash stored hard address
value)
Note: Only valid AL_PAs may be used.
Restart
InitTimeout=n Determines the number of time-out seconds during driver initialization
for the link to come up. If the link fails to come up by InitTmeout, driver
initialization exits but is still successful. If the link comes up before
InitTimeout, the driver sets double the amount for discovery to
complete.
Value: 5 -30 seconds or 0x5 - 0x1E (hex)
Default = 15 seconds (0xF)
Reboot
LinkSpeed=n LinkSpeed has significance only if the HBA supports speeds other
than one Gbit.
If set to 0 = auto link speed detection.
If set to 1 = 1 Gbit.
If set to 2 = 2 Gbit.
If set to 4 = 4 Gbit.
Value: 0, 1, 2 and 4
Default = 0
Note: Setting this option incorrectly may cause the HBA to fail to
initialize.
Restart
LinkTimeOut=n This parameter applies to private loop only. A timer is started on all
mapped targets using the link timeout value. If the timer expires
before discovery is re-resolved, commands issued to timed out
devices will end up returning a SELECTIION_TIMEOUT. Storport will
also be notified of a bus change event which will lead to the removal
of all LUNs on the timed out devices.
Value: 1 - 500 seconds or 0x0 - 0xFE (hex)
Default = 30 (0x1E)
Dynamic
Table 1: Storport Miniport Driver Parameters (Continued)
Parameter Definition s Activation
Requirement