The HBAnyware Utility User Manual Page 68
Driver For Solaris SFS Parameters• The emlxs.conf file contains all the parameters necessary to initialize the Solaris SFS dr iver.
• The HBAnyware utility reflects the Solaris SFS driver parameters.
The parameter values listed in Table 4 a re applicab le to driver versio ns 1.22/2.22 o r later. If you are
using a version previous to 1.22/2.22, see the Emulex Driver for Solaris User Manual for parameter
information. All parameters are controller-specific.
Note: If any of the default parameter values were changed, verify that this change will not
impact the migration before you migrate.
Table 4: emlxs.conf Parameters
Property
Name Default Min Max Activation Comments
ack0 0 0 1 Requires
link reset Use ACK0 for class 2.
If ACK0 is 1, the HBA
tries to use ACK0
when running Class 2
traffic to a device. If
the device doesn’t
support ACK0, then
the HBA uses ACK1.
If ACK0 is 0, only
ACK1 is used when
running Class 2 traffic.
adisc-support 1= Partial
support.
Flush
I/O's for non-
FCP2 target
devices at
link down.
0 = No
support.
Flush active
I/O's for all
FCP target
devices at
link down.
2 = Full
support. Hold
active I/O's for
all devices at
link down.
Dynamic Description: Sets the
level of driver support
for the FC ADISC
login I/O recovery
method.
assign-alpa 0x00 0x00 0xef Requires
link reset This is only valid if
topology is loop. A
zero setting means no
preference. If multiple
adapter instances on
the same host are on
the same loop, you
should set this value
differently for each
adapter.
console-
notices 0x00000000 0x00000000 0xFFFFFFFF Requires
reboot. Verbose mask for
notice messages to
the console.
console-
warnings 0x00000000 0x00000000 0xFFFFFFFF Requires
reboot. Verbose mask for
warning messages to
the console.