INSPEED™ SAN STORAGE SWITCH MODEL 355 CHAPTER 2 SWITCH INSTALLATION
USER’S GUIDE
7
SWITCH INSTALLATION
The switch may be placed on a desktop or installed in a rack.
Desktop Installation
To place the switch on a desktop:
1. Turn the switch upside down so the case bottom is facing up.
2. Install a self-adhesive pad (included) on each corner of the switch bottom approximately 1 inch
from each side (prevents surface damage).
3. Turn the switch right-side up so the case bottom is facing down and place the switch on a stable
table or platform.
For information on environmental requirements, see “Operating Conditions” on page 61.
Rack Installation
Installing the switch in an equipment rack requires an optional rack mount kit (sold separately). The rack
mount kit holds two switches. Contact a sales representative for more information or assistance in
purchasing a kit.
Installing the switch(es) in a rack requires the following items:
• Rack mount kit (Part Number 00651359-701)
• 4 thread forming screws, 6-32 x 1/4 100° (included in the Rack Mount Kit)
• No. 2 Phillips screwdriver
To install the switch(es) in the tray:
1. Turn the switch(es) over (upside-down) on a flat surface.
2. Turn the tray over (upside-down) and place it on top of the switch(es).
3. Align the tray and the switch(es) using the four holes indicated in Figure 2-1. Make sure the back
lip of the tray is aligned with the back side of the switch(es).
Note: Important safety, electromagnetic compatibility, and regulatory information is
contained in the
Safety & Regulatory Guide
. The installation and use of this product
must be in accordance with the information given in that guide.