Emulex NQGB-NT+, NP02, NQ0V-NT+, NJ01B-NT+, NQTR0U-NATM, NQ0U-NT+ manual Requirements, Select Printer

AppleTalk 6-1

Requirements

Before beginning, verify the network conforms to these requirements:

•AppleTalk Phase 2

•System 6 or System 7

•LaserWriter driver 8.0 or newer

Before Installation

We recommend writing down the following parameters from the Setup Section in Chapter 2. Refer to them during the installation procedure.

Default Server Name: ____ ____ ____ ____ ____ ____ ____ ____ ____

Default Printer Name: ___ ___ ___ ___ ___ ___ ___ ___ ___ _ ___

IP Address: ___ ___ ___-___ ___ ___ -___ ___ ___-___ ___ ___

Select Printer

NOTE: Verify the printer server is connected to the network and printer. Power up the printer and printer server.

From the APPLE menu:

1)Click CHOOSER.

2)Select the LASERWRITER or LASERJET icon.

3)Select the appropriate Zone, if available.

4)Select the Emulex default printer name. See Before Installation section above.

5)Close CHOOSER.