Enterasys Networks 7KR4297-02, 7KR4297-04 Completing the Installation of a New System

Completing the Installation

Matrix DFE-Platinum Series Module Installation Guide 3-17

Completing the Installation of a New System

InanewsystemofDFE‐Diamondmodules,oneoftheinstalledDFE‐Diamondmoduleswill

becomethemanagementmoduleonchassispowerup,andallDFE‐Diamondmoduleswill

automaticallybesettothefactorydefaultvalues.Acompletelistofthefactorydefaultvalues are

providedinChapter3oftheEnterasysMatrixDFE‐Diamond/PlatinumSeriesConfigurationGuide.

AfterinstallingallDFE‐Diamondmodulesintothehostchassisandmakingtheconnectionstothe

network,proceedtothefollowing“First‐TimeLog‐InUsingaConsolePortConnection”

proceduretoaccessthemodulemanagementstartupscreenfromyourPC,terminal,ormodem

connection.

StarttheCommandLineInterface(CLI)fromthemodule’slocalconsoleportasfollows:

1. Connectaterminaltothelocalconsoleportasdescribedin“ConnectingtoCOMPortfor

LocalManagement”onpage3‐11.Thestartupscreen,Figure 3‐8,displays.

2. Attheloginprompt,enteroneofthefollowingdefaultusernames:

–roforRead‐Onlyaccess,

–rwforRead‐Write access,or

–adminforSuperUseraccess.(This accesslevelallowsRead‐Write accesstoallmodifiable

parameters,includinguseraccounts.)

3. PressENTER.

4. ThePasswordpromptdisplays.LeavethisstringblankandpressENTER.Themodule

informationandMatrixpromptdisplaysasshowninFigure 3‐8.

TheDFE‐Diamondmoduleisnowreadytobeconfigured.ForinformationaboutsettingtheIP

addressandconfiguringTelne tsettingsforremoteaccesstoDFEmanagement,refertoChapter3

intheEnterasysMatrixDFE‐Diamond/PlatinumSeriesConfigurationGuide.TheCLIcommands

enableyoutoinitiallysetupandperformmoreinvolvedmanagementconfigurations.

TheEnterasysMatrixDFE‐Diamond/PlatinumSeriesConfigurationGuideisavailableonlineat:

http://www.enterasys.com/support/manuals

Ifyourequireassistance,contactEnterasysNetworksusingoneofthemethodsdescribedin

“GettingHelp”onpagexiv.

Note: This procedure applies only to initial log-in, and to logging in to a device not yet configured

with administratively-supplied user and password settings.

By default, the Matrix DFE Series device is configured with three user login accounts: ro for Read-

Only access; rw for Read-Write access; and admin for super-user access to all modifiable

parameters. The default password is set to blank (press ENTER). For information on changing

these default passwords, refer to Chapter 3 in the Enterasys Matrix DFE-Diamond/Platinum Series

Configuration Guide.