Envision Peripherals EN9410e user manual Hardware Installation, Power cable 2. D-sub Video Cable

4 Hardware Installation

Your monitor is equipped with an automatic power supply with a voltage from 100 to 240 Volts AC at a frequency of 50 to 60 Hz. Make sure tha local power supply is within the supported range. If you are unsure, contact your electricity supplier.

To install your Envision EN9410e monitor:

1.Make sure that the power to the computer and the power to the monito both turned off.

2.Connect the D-sub video cable from the monitor￿s VGA input connecto the VGA output connector of the computer￿s graphics card.

3.Connect the power cord from the monitor￿s power jack to an AC po socket. Please make sure, that you have easy access to the power so so you can disconnect the unit from the power socket should you need

1. Power cable

2. D-sub Video Cable

4