Installation |
|
Figure 9 shows the layout of Slot 1 and the holes for mounting the Heatsink base piece (figure 8).
Motherboard
Layout
Large Hole for Heat Sink Base | Small Hole for Heat Sink Base |
| Figure 10 |
Now we are ready to install the SEC Cartridge (Pentium II Processor) into the Retention Module. The SEC Cartridge is mounted by sliding the SEC Cartridge into the Retention Module and letting it slide all the way down. Once it reaches the bottom make sure you press firmly on SEC cartridge to firmly secure into the Slot 1 Socket.
Now we need to secure the heatsink with the top half of the support (figure 11). Take the top piece of the support and slide it into the bottom fin (figure 11) on the heatsink and then push forward until it clips into the bottom base (figure 9) that is already there (figure 11).
Bottom fin | Bottom fin |
of heatsink | of heatsink |
Top half of the support
Figure 11
Page
