Installing the EpsonScript and LocalTalk boards
1. Unpack the EpsonScript and LocalTalk boards.
Follow these guidelines when handling the EpsonScript and LocalTalk boards:
Do not drop or bend.
Do not store in direct sunlight or near a heat source.
Make sure the printer is turned off when you insert or remove the boards; otherwise, you can damage the boards or the printer.
Do not touch the connectors. If the connectors become dirty, clean them by wiping the edge with a clean tissue. Do not use water, alcohol, or other solvents.
2.Hold the EpsonScript board so its CN1 connector is face down and position it over the CN3 connector on the controller board.
3.Insert the connector on the EpsonScript board into the CN3 connector as shown below.
Setup