OPERATION

OPERATIONAL CONTROLS AND ADJUSTMENTS

STARTING AND STOPPING MACHINE

SINGLE PHASE MACHINE

The on-off push button switch is located on the motor junction box. To turn the machine “ON” push the start button (A) Fig. 18, and to turn the machine “OFF” push the stop button (B).

A

B

Fig. 18

LOCKING SWITCH IN THE “OFF” POSITION

IMPORTANT: When the machine is not in use, the switch should be locked in the "OFF" position using a padlock

(C)Fig. 19, with a 3/16" diameter shackle to prevent unauthorized use.

In the event of a power outage, always lock switch in “OFF” position until the main power is restored.

C

Fig. 19

STARTING AND STOPPING MACHINE

THREE PHASE MACHINE

On the three phase machine the switch is located on the left front side of the planer head assembly, as shown in Fig. 19A. To turn the machine “ON” press the start button (C), and to turn the machine “OFF” press the stop button (D).

C

D

Fig. 19A

OVERLOAD PROTECTION (Three Phase Machine Only)

The three phase machine is provided with overload protection which will shut off the motor if the planer is overloaded or if line voltage falls below safe levels. If the motor shuts off due to overloading or low voltage, let the motor cool for approximately five minutes. The overload block supplied with the machine will automatically reset itself and the machine can then be started again by pushing the start button. IMPORTANT: If the machine continually shuts off due to overloading, the cause of overloading must be corrected. If this happens, it is recommended you obtain advice from a qualified electrician.

12

Page 12
Image 12
Epson 22-681 instruction manual Operation, Starting and Stopping Machine, Locking Switch in the OFF Position