note

The name of the selected image source appears in the upper right corner of the screen.

Selecting the Image Source

Selecting the image source lets you switch between images input from different pieces of equipment connected to the projector (such as a computer and DVD player). If you don’t see the image you want, press one of the following buttons on the remote control:

■Comp1

Press this button to move through the following options:

Computer1 (Auto), Computer 1 (RGB), and Computer 1 (Component Video).

■Comp2

Press this button to move through the following options:

Computer 2 (Auto), Computer 2 (RGB), Computer 2 (Component Video).

■S-Video

Press to select S-Video.

■Video

Press to select Video.

You can also press the Source Search button on the remote control or projector until the correct device image is projected. If a projected image fails to appear, see the next section for help.

Once you see your image, turn to page 37 for instructions on focusing and making other image adjustments.

What To Do If You See a Blank Screen

If you see a blank screen or a blue screen with the message No Signal after turning on your computer or video source, try the following:

■Make sure the cables are connected correctly, as described in Chapter 1.

■Make sure the power light is green and not flashing and the lens cap is off.

■Make sure you’ve selected the correct image source; see the previous section. Allow a few seconds for the projector to sync up after pressing the button.

34Projecting