note

You can also adjust the volume using the projector’s Settings menu. See page 60 for details.

You must adjust the volume separately for each input source.

Adjusting the Volume

You can use the buttons on the remote control or projector to increase or decrease the volume for both the projector’s built-in speaker and external speakers connected to the projector. Press the button to increase the volume, or the button to decrease it. A volume gauge appears on the screen while the volume is being adjusted.

Volume controls

note

When the projector has not received any input signals for 30 minutes, it automatically turns off the projector lamp and enters “sleep mode.” This conserves electricity, cools the projector, and extends the life of the lamp. If you are done using the projector, unplug the power cord. If you want to start projecting again, press the P Power button. You can turn sleep mode on or off through the Extended menu. See page 63.

Shutting Down the Projector

When you’ve finished using the projector, follow the recommended procedure to shut it down.

1.If you’re using a computer, shut it down first; otherwise you may not be able to see your computer’s display to shut it down properly.

2.To turn off the projector, press the P Power button on the projector or remote control.

You see this confirmation message: (If you don’t want to turn it off, press any other button or wait a few seconds until it disappears.)

3.Press the P Power button again. The projector beeps twice, the lamp is turned off, and the power light turns orange.

With Epson’s exclusive Instant Off™ technology there’s no cool-down period, so you can pack up and go immediately after turning off the projector.

42Projecting