2.Once the image is positioned where you want, release the lever to lock the foot in position.

3.To fine-tune the height of the image, rotate the foot at the back of the

projector.

If the image is no longer rectangular after raising it, see the next section.

Adjusting the Image Shape

Pointer button

The projector automatically corrects images that are distorted when the projector is tilted up or down (up to a 30° tilt). The Keystone window appears on the screen while the projector makes the correction. If the projected image still isn’t rectangular or has a “keystone” shape, do one or more of the following:

■ If your image looks like or , you’ve placed the projector off to one side of the screen, at an angle. Move it directly in front of the center of the screen, facing the screen squarely.

■ If your image looks like

or

, the Auto Keystone feature

may have been disabled or you may need to manually adjust the

keystone correction value. (Auto Keystone is not available when

you’re using ceiling or rear projection.) Follow the directions

below:

 

Enter button Menu button

■To turn on Auto Keystone, press the Menu button on the remote control. Use the pointer button on the remote control (or the arrow buttons on the projector) to select the

Settings menu, then press Enter. If Auto Keystone is OFF, use the pointer button to highlight this option and press Enter. Select ON in the Auto Keystone window that appears and press Enter to save your changes. Exit the menu by pressing the Menu button.

Projecting 39