Making Other Computer Connections

If you want to connect a computer using the BNC cable or connect a high-end workstation or a Digital Visual Interface (DVI) source, follow the instructions below.

Connecting a Computer Using the BNC Cable

Follow these steps to connect a computer to the Computer 2/ Component Video interface using the BNC cable:

1.Connect the VGA (D-sub 15-pin) end of the cable to your computer’s video port.

2.Connect the five connectors at the other end of the cable to the projector’s R/Cr/Pr (red), G/Y (green), B/Cb/Pb (blue), H/C Sync (horizontal sync), and VSync (vertical sync) ports, shown below.

 

Computer 1

 

Computer 2 /Component Video

 

BNC connectors

R/Cr/Pr

G/Y B/Cb/Pb H/C Sync V Sync

Remote

Audio

 

Mouse/Com

3.To display images properly, make sure the BNC parameter in the projector’s Setting menu is set to RGB. See page 69.

4.If you want to hear computer-audio through the projector, you’ll need an RCA-to-3.5 mm stereo cable (available for purchase from your electronics store or video dealer). Insert the cable’s 3.5-mm plug into your computer’s audio-out port. Then attach the RCA connectors at the other end of the cable to the S-Audioand Audio2 ports of the projector.

Setting Up the Projector 33