Power

Freeze

A/V Mute

R/C ON

E-ZoomOFF

 

3

2

4

1

5

 

Enter

Esc

ON/OFF switch

The temperature light is flashing orange.

The projector is too hot. Press the Power button to turn it off and let it cool for 5 minutes before using it again.

The temperature light is flashing red.

The cooling fan or temperature sensor is not working correctly and the projector is too hot. Turn it off, unplug it, and contact EPSON.

Problems with the Remote Control

The projector doesn’t respond to remote control commands.

■Make sure the remote control is turned on.

■Make sure you are within 30 feet of the projector, and within range of the infrared receivers (approximately 30° to the left or right and 15° above or below).

■The remote control batteries may not be installed correctly or may be low on power. Check the installation or replace them as described on page 12.

■Dim the room lights and turn off any fluorescents. Make sure the projector is not in direct sunlight. Strong lighting, especially fluorescent lights, may affect the projector’s infrared receivers.

■Turn off any nearby equipment that emits infrared energy, such as a radiant room heater.

You can’t control the mouse pointer with the remote control.

■Make sure the mouse cable is securely connected to both your computer’s mouse port (using the main cable) and the projector’s mouse port. See Chapter 1 for details.

■Make sure you have used the correct cable. The PS/2 mouse cable and Macintosh mouse cable look the same, but they are not identical. Check the label on the end of the cable.

86Solving Problems