Note: To be able to use the remote control as a wireless mouse, make sure you’ve connected the mouse cable to the projector and your computer. (See Chapter 1 for instructions.)
The five Special Effects buttons are preprogrammed with the following options:
1Change the mouse cursor to a stamp
2Draw a box
3Use a marker pen
4Draw a freehand line
5Clear the screen
For information on changing these special effects, see page 107.
The projector may not respond to remote control commands in these conditions:
❐The R/C (remote control) on/off switch is in the OFF position
❐Batteries are weak
❐Ambient light is too bright
❐A certain type of fluorescent light is present
❐A strong light source (such as direct sunlight) shines into the infrared receiver
❐Other equipment emitting infrared energy is present (such as a radiant room heater)
Correct these conditions to use the remote control or control the projector from a computer.
Controlling the Projector | 75 |