To select a setting click the button for that setting, then adjust the controls.

When you’ve made changes, click OK to exit. Your settings take effect immediately.

N O T E

If you install another pointing device and then want to return to the ActionPoint, you need to reinstall the ActionPoint drivers. Type the following commands at the MS-DOS prompt:

CD\SYNTOUCH

INSTALL

Customizing Computer Settings

Setup configures your ActionNote and stores the settings in the computer’s CMOS ROM (read-only memory). Because this area of memory is backed up by a battery, it is not erased when you turn off or reset the computer.

The current configuration is probably fine for most of your needs. However, you may need to run Setup when you upgrade your computer or connect new equipment. You can also run Setup to customize power management.

Customizing Your Computer 6-3