Epson Action Laser o r, Note:, To exit, When you, Press the, Press the, 8. Use the, To implement, Hold down the, Using the Printer, Exit SelecType and reset the printer

Using SelecType

7.Press the SET button to activate the option. The function stops blinking, and the option starts blinking.

8. Use the o r button to move to the option you want to set.

9.Press the SET button. An asterisk (*) appears next to the option, indicating that the new option has been set. The option stops blinking and the function starts blinking.

10.To exit the emulation submenu and return to the main menu,

use the or button to take you back to the main menu. The message I/F = SERIAL* appears in the display.

If you wish to exit SelecType at this point, see the section below on exiting SelecType.

Exit SelecType and reset the printer

To exit SelecType (from any main menu or submenu function) and implement your changes, follow these steps:

1.When you have set all the options you want, press the SelecType button. The printer is set off line.

2.Hold down the CONTINUE/RESET button for three seconds (until the message RESET appears) to implement your changes. The options are implemented in the printer’s memory until you change them or initialize them to the factory settings.

Note: To implement changes to the DATA BUFFER, OVER LOAD, and interface submenu settings you must also turn the printer off. Remember to leave the printer off for at least five seconds before turning it back on.

Using the Printer 3-17