You have been using your hard disk drive successfully far same time but notice a reduction in performance.

The data on the disk may have become fragmented. Back up all your data and use a disk compaction utility to reorganize the files on your disk.

If you cannot access data on your hard disk or you are seeing read/write errors, the disk may have a physical problem. Contact your Authorized EPSON Servicer or the EPSON Connection.

Password Problems

You have forgotten your password.

You must discharge your CMOS memory. To do this, you need to change the setting of jumper J30 to position 3-4. See Chapter 3 for details on changing the jumper setting.

After you have changed J30, restart your system, leave it on for a few seconds, then turn it off again. This resets the SETUP

values to their factory defaults. Both the Supervisor and the User passwords are disabled.

Set J30 back to position 2-3. Then turn the computer on again. Use SETUP to set a new password, if you want one.

5-10 Troubleshooting