Epson ActionTower 3000 Computer Post-SETUPProcedures, over, to CMOS, made using SETUP, you have made to CMOS, If you change your system, 1-20Setting Up Your System, Load, from, CMOS, Save

Exiting SETUP

When you leave SETUP, you can save your settings, or exit SETUP without saving your settings. You can also return all values to the factory defaults.

To leave SETUP, press ESC from any SETUP screen. From the Main Menu, you can do the following:

Load ROM		Loads the factory default settings
Default Values		stored in ROM back into CMOS.
		If you change your system
		configuration and then have
		problems, you can load the ROM
		values to boot the system and start
		over.
Load	Values	Loads the current values stored in
from	CMOS	CMOS for all SETUP options. This
		ignores any changes you have
		made using SETUP.
Save	Values	Saves the configuration changes
to CMOS		you have made to CMOS.

Post-SETUP Procedures

After you run SETUP for the first time, you may need to install the operating system if your computer is not preconfigured. See your operating system manual for instructions.

Once you have installed your operating system, install any software you plan to use. See your application program manuals for instructions.

1-20 Setting Up Your System