Inserting SIMMs

Follow these steps to install SIMMs:1.Refer to the illustration on page 3-5 to locate the SIMM sockets.2.Turn the computer around so the back panel is facing you.

3.Remove the four screws securing the rear internal drive bay bracket to the computer’s back panel. Then slide the bracket out of the computer and set it aside for now.

4.Rest the computer on its side, so that the system board is flat and the components are easy to reach.

5.Position the first SIMM at an angle over the first empty socket in the bank you are filling, as shown in the next illustration. The components on the SIMM should face the power supply.

3-12 Installing and Removing Options