3.Also, you may need to remove the rear internal drive bay bracket to access the jumpers. (If there is a drive mounted in this bracket, you’ll need to remove it first; see Chapter 4 for instructions.) Remove the four screws that hold the bracket to the back of the system, as shown below.

4.Rest the computer on its side, so that the system board is horizontal and the components on the board are easy to r e a c h .

5.Use needle-nose pliers or tweezers to pull the jumper off its pins and gently move it to the desired position or remove it from the computer.

C a u t i o n

Be careful not to bend the jumper pins or damage any surrounding components on the main system board.

6.Replace the rear internal drive bay bracket, if necessary.7.Replace any option cards you removed; see page 3-15.

Installing and Removing Options

3-9