Setting Auto Shut-off
PhotoPC’s
You can adjust this time period by connecting the camera to your Macintosh and using PhotoPC Settings. Follow these steps:
1Connect the camera to your Macintosh as described in Chapter 3 and open the Setup window as described on page
The Auto
2Drag the slider to the left to reduce the time period, or to the right to increase it.
As you move the slider, the screen shows the number of minutes. You can select from 0 to 5 minutes.
If you select 0, the camera shuts off immediately after your picture is captured and saved to memory. When you turn it back on, you have just 30 seconds to take a picture after the standby light stops flashing.
3When you are finished, click OK.
NOTE
Auto
Setting the Shutter Speed
When the camera is connected to your Macintosh, you can use PhotoPC Settings to adjust the shutter speed. Slower shutter speeds allow more light to strike the lens; faster speeds allow you to take
The factory shutter speed is Auto, which means that PhotoPC automatically adjusts the shutter speed based on the amount of light
available. You will probably want to use this setting most of the time, 5 unless you are planning to take
lighting effects.
NOTE
When you adjust the shutter speed manually, you can’t use the
auto flash setting. To take a picture with the flash, you need to use the forced flash setting. See page
Using Advanced Features