English
Additional Information
Adjustment:
•If you add a Mobile Base to your saw it will be necessary to adjust the height of the legs on your 52" Rail System:
•Place the Mobile Base under your saw as described in the mobile base instruction manual.
•Move the saw to the location you will most likely use it and disengage base.
•Loosen the M8 cap head screw through the open ended slot in each side rail and the square hole in the legs (Fig. 6). Use the adjusting hardware through the top of the legs to adjust the leg set all the way down or until the M8 screws are at the bottom of the open ended slots..
•
•For each leg (Fig. 19): Loosen the two screws that hold the foot to the leg. Let the foot fall to the floor sur- face.
Adjust the rear fence glide
If necessary, adjust the rear glide to locate it correctly against the rear rail by loosening the two screws which secure it to the fence beam. The plastic retaining clip should be deflected somewhat when the glide is posi- tioned correctly. This adjustment should only be necessary if the rear rail has been relocated by the addition of an optional accessory.
Cleaning:
•The table board of your 52" Rail System is a composite material, excessive moisture can cause deterioration. Cleaning with a damp cloth or a mild solvent on the top surface is acceptable, but the edges of the board should not be wetted.
6
