E
Repeat procedures 3 and 4 as needed to adjust any
remaining corners.
F
When you are done, press the [Esc] button to exit the
correction menu.
Because the correction method was changed to Quick Corner
from Keystone in the configuration menu, when [w/], [v/],
[</], and [>/] buttons are pressed later, the screen for
selecting the corner in procedure 2 is displayed. Change Keystone
from the configuration menu to H/V-Keystone if you want to
correct H/V-Keystone when pressing the [w/], [v/], [</],
and [>/] buttons on the control panel.
q
If the [Esc] button is held down for about two seconds while
correcting with Quick Corner, the following screen is displayed.
Reset Quick Corner: Resets the result of Quick Corner corrections.
Switch to H/V-Keystone: Switches the correction method to H/
V-Keystone. s p.45
Correcting Distortion in the Projected Image
17