Command List
When the power ON command is transmitted to the projector, the
power turns on and it enters warm-up mode. When the projector's
power has turned on, a colon ":" (3Ah) is returned.
When a command is input, the projector executes the command and
returns a ":", and then accepts the next command.
If the command being processed terminates abnormally, an error
message is output and a ":" is returned.
Item Command
Power ON/OFF On PWR ON
Off PWR OFF
Signal selection Computer Auto SOURCE 1F
RGB SOURCE 11
Component SOURCE 14
BNC Auto SOURCE BF
RGB SOURCE B1
Component SOURCE B4
HDMI SOURCE A0
DVI-D SOURCE 30
Video SOURCE 45
S-Video SOURCE 42
Shutter On/Off On MUTE ON
Off MUTE OFF
Add a Carriage Return (CR) code (0Dh) to the end of each command
and transmit.
Cable Layouts
Serial Connection
•Connector shape: D-Sub 9-pin (male)
•Projector input port name: RS-232C
<At the projector> <At the computer>
<At the projector> (PC serial cable) <At the computer>
Signal Name Function
GND Signal wire ground
TD Transmit data
RD Receive data
Communications protocol
•Default baud rate setting: 9600 bps
ESC/VP21 Commands
90