12
Before Using the Remote Control

Using the Remote Control and Remote Operating

Range

When using the remote control for the first time, pull out the insulating
tape that is protruding from the battery holder. When the insulating tape is
pulled out, the remote control can then be used.
The remote control is used in the following way.
PROCEDURE

Point the remote control light-emitting area toward one of

the remote control light-receiving areas on the projector

and operate the remote control buttons.

Using the Remote Control

Insulating tape
Remote control
light-receiving
area (front)
Remote control
light-receiving
area (back)
Remote control
light-emitting area
TIP
•Do not allow sunlight or light from fluorescent lamps to shine
directly onto the projector's remote control light-receiving areas,
otherwise it may interfere with the reception of signals from the
remote control.
•If delays in the responsiveness of the remote control occur or if it
does not operate after it has been used for some time, it probably
means that the battery is getting flat. If this happens, replace the
battery with a new one. p.84
•When not using the remote control, place it into the remote control
holder underneath the projector so that it does not get lost.
Hook a finger into the middle
of the remote control holder
and pull it downwards.
After placing the remote control into
the holder, push the remote control
holder in until it clicks into place.