User’s Guide

Preventing theft (Password Protect)

 

59

 

 

 

TIP

•If an incorrect password is entered three times in succession, the message "The projector’s operation will be locked." will be displayed for approximately five minutes, and then the projector will switch to standby mode. If this happens, disconnect the power plug from the electrical outlet and then reinsert it and turn the projector's power back on. A window requesting you to enter the password will be displayed, so enter the correct password.

If you happen to forget the password, make a note of the "Request Code: xxxxx" number that appears in the Password screen and contact the nearest address provided in the "International Warranty Conditions" section of the Safety Instructions/World-Wide Warranty Terms booklet.

•If you repeat the above operations ten times resulting in an incorrect password being entered thirty times, the following message will be displayed and the projector will not accept password entries any more.

"The projector’s operation will be locked. Contact the nearest address provided in the "International Warranty Conditions" section of the Safety Instructions/World Wide Warranty Terms booklet."

When "Password Timer" is set to "ON" and "Timer" is used

The password entry screen will not be displayed at all when the power is turned on until the length of time that has been set has elapsed. When the set length of time has elapsed, the password entry screen will be displayed each time the power is turned on. The length of time referred to here is the total illumination time for the projector's lamp from the point when the projector's menu is closed.

If "Password Timer" is set to "OFF", the password entry screen will be displayed each time the power plug is disconnected and reinserted from the electrical outlet. If the projector's power on when it is in standby mode, the password entry screen will not be displayed.

When "User ’s Logo Protect" is enabled (ON)

If an attempt is made to carry out any of the following user logo operations, a message is displayed and the setting cannot be changed. To

change the setting, set "User’s Logo Protect" to "OFF" first. p.61

•Capturing a user's logo

•Changing the setting for the "No-Signal Msg." command in the "Setting" menu from "Logo" to "Black", "Blue" or "OFF", or when changing it from "Black", "Blue" or "OFF" to "Logo"

•Changing the setting for the "A/V Mute" command in the "Setting" menu from "Logo" to "Black" or "Blue", or when changing it from "Black" or "Blue" to "Logo"

•When the "Advanced1" - "Startup Screen" menu setting ("ON" or "OFF") is changed.