•Refer all servicing to qualified service personnel. Servicing is required when the unit has been damaged in any way, such as the
•Do not expose this unit to water or place objects containing liquids on this unit.
•Do not place the source of a naked flame, such as a lit candle, on this unit.
•Connect this unit to an earthed electrical outlet.
•Ensure there is at least 20 cm between the exhaust vent and any walls, and so on.
•Ensure there is at least 10 cm between the air intake vent and any walls, and so on.
•Do not project when the lens cover is on.
It is possible that the lens cover may melt from the heat and cause burns or injuries.
To interrupt the projection, press [Image On/Off] during projection.
•Do not leave this unit or the remote control with its batteries installed in such places as the inside of a car with the windows closed, in direct sunlight, near the intake/exhaust of an air conditioner or heater, or in places where the temperature rises above normal. This may have a negative effect upon the internal parts of this unit and cause heat deformation or fire.
•When unplugging the power plug/power connector, do not pull on the power cable.
Make sure you grasp the plug or connector part, then unplug.
•Do not set the volume too high from the outset. A loud sound may be produced suddenly that may cause damage to the speaker or your hearing. As a precaution, lower the volume before you switch off this unit then raise it gradually after you switch it back on.
•When using headphones, do not turn the volume up too loudly.
You may adversely affect your hearing when listening at loud volumes over extended periods of time.
•When maintaining this unit, remove the power plug/ power connector form the wall outlet.
If not, you run the risk of an electric shock.
•Do not place the projector on an unstable cart, stand, or table.
•Use the type of power source indicated on the projector. If you are not sure of the power available, consult your dealer or local electricity company.
•Place the projector near a wall outlet where the plug can be easily unplugged.
•Check the specifications of the power cable. Using an inappropriate power cable could result in fire or electric shock.
The power cable supplied with the projector is intended to comply with power supply requirements for the country of purchase.
•Take the following precautions when handling the plug. Failure to comply with these precautions could result in fire or electric shock.
−Do not insert the plug into an outlet with dust present.
−Insert the plug firmly into the outlet.
−Do not handle the plug with wet hands.
•Do not overload wall outlets, extension cables, or integral convenience receptacles. This can cause fire or electric shock.
•Do not place the projector where the cable can be stepped on. It may result in fraying or damage to the plug.
•Unplug the projector from the wall outlet before cleaning. Use a damp cloth for cleaning. Do not use liquid or aerosol cleaners.
•Do not block the slots and opening in the projector case. They provide ventilation and prevent the projector from overheating. Do not place the projector on a sofa, rug, or other soft surface, or in a
•Never push objects of any kind through cabinet slots. Never spill liquid of any kind into the projector.
•Unplug the projector from the wall outlet and refer servicing to qualified service personnel under the following conditions:
−When the power cable or plug is damaged or frayed.
−If liquid has been spilled into the projector, or it has been exposed to rain or water.
−If it does not operate normally when you follow the operating instructions, or if it exhibits a distinct change in performance, indicating a need for service.
−If it has been dropped or the housing has been damaged.
3