Use and Storage
Take note of the following advice in order to prevent malfunction and damage.
Notes on handling and storage
•Use and store this unit within the operating temperature range and storage temperature range as specified in this manual.
•Do not install the unit in a place prone to vibration or shock.
•Do not install the unit close to television, radio or video equipment that generates magnetic fields.
This may have a negative effect when projecting the playback of audio and image with this unit, and may cause this unit to malfunction.In the event that such symptoms occur, move the unit further away from any television, radio and video equipment.
•Do not install this machine on an incline.
•Do not move this unit during playback.
This may damage the disc or cause malfunction.
•Avoid using or storing this unit in cigarette or other smoke filled places, or in rooms containing a large amount of dust.
This may cause degradation of the image quality.
•Do not touch the projection lens with your bare hands.
If fingerprints or marks are left on the face of the lens, the image will not be projected clearly.Make sure the lens cover is securely in place when not in use.
•EPSON will not be held responsible for damage arising from projector or lamp failure outside the range of that which is covered in your warranty terms.
Condensation
If you move this unit from a cold place into a warm room, or, if the room in which this unit is installed is heated rapidly, condensation (moisture) may form internally or on the lens surface.If condensation forms, it may not only cause incorrect operation such as weakening of the image, but also damage the disc and/ or parts.In order to prevent against condensation, setup this unit in the room approximately one hour before it is to be used.If by some chance condensation does form, turn on the main power switch then wait one to two hours before use. Do not use the lamp during this time.
Lamp
This machine uses a mercury lamp with a high internal pressure as its light source.Mercury lamps have the following characteristics.
•Lamp brightness decreases once the rated lamp usage time has passed.
•When the lamp reaches the end of its life, it may enter a state where it will no longer light, or it may explode with a loud noise due to impact, deterioration, or the expiration of its usage time.
•Depending on the individual difference of each lamp and the conditions of use, there is a considerable difference in the time it takes for the lamp to reach the end of its life.
To provide against contingencies, prepare a replacement lamp in advance.
•The potential for the lamp to explode increases once the lamp usage time has been exceeded.
When the lamp replacement message appears, promptly replace the lamp with a new one.
LCD panel
•Although the liquid crystal panel is made using very precise high technology, you may see some black pixels, or pixels that are always lit red, blue, or green.You may also be able to see lines with irregular brightness or color.
These are normal characteristics of liquid crystal panels, and are not indicative of any malfunction.Be aware of this fact.
•Do not leave this unit projecting a still image over a long period of time.
It is possible that remnants of the image may remain (screen burn). You may be able to avoid screen burn by switching off the power and leaving the projector for a while.If the screen burn does not disappear, contact your dealer for advice. s page 65
5