Appendix

Troubleshooting

Reading the indicators

You can check the status of this unit using the indicators on the top panel.

Check each condition in the following table and follow the steps to remedy the problem.

* If all indicators are switched off, check that the power cable is connected correctly and whether or not the main power switch is turned on.

When flashes green / orange alternately
Error

: flashing green/orange alternately

: lit : flashing : off

 

 

Red Red

Red

Internal error

Turn the main power switch off then on. If

the indicator status does not change once

 

 

has been pressed and the power

 

 

 

 

Disconnect the power cable from the electrical

 

 

switched on

 

 

 

 

Fan related error/Sensor error

 

 

 

 

 

outlet and contact your dealer.

 

 

 

 

s page 65

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Red

High temperature error (overheating)

The lamp turns off automatically and projection stops. After being in this state for around 40 seconds and then entering stand-by mode, check the 2 items listed to the right.

If the power was turned off, turn the main power switch back on again.

•Move this unit away from the wall by at least 20 cm.

•Clean the air filter. s page 56

If the indicator status does not change

once has been

pressed and the power turned on

Red

Lamp error/Lamp fails to light up/Lamp cuts out /Lamp cover open

Check if the lamp is broken. s page 58

 

Reinsert the lamp then turn on the main power

If the condition is not

The lamp is not broken

 

 

fixed once the lamp

switch on the main unit and press

.

 

is re-inserted

 

 

 

 

 

 

 

The lamp is broken

Contact your dealer. s page 65

 

 

52