Turning On Your Equipment
Make sure your document camera and other equipment are set up and connected correctly, as described in Chapter 1. Always turn on your projector or monitor first. Then turn on your document camera, as described below, followed by any other equipment you’ve connected to it.
If you have one or two computers connected to the document camera’s RGB INPUT ports, you may have to switch between sources to see the desired image. See page 24 for details.
Turning On the Document Camera
Follow these steps to plug in and turn on the document camera:
1.Connect one end of the power cord to the document camera’s power inlet.
Power inlet
2.Connect the other end to a grounded electrical outlet.
3.Turn on the projector or monitor.
4.Turn on the document camera. After a moment, the upper lamps turn on.
On/Off 
switch
22Using the Document Camera