Epson FX-286 1-20), Running the Self Test

Running the Self Test

8 The FX-286 has a built-in self test function that automatically prints out all of the characters in the printer’s character set, even if it’s not connected to a computer.

Before running the self test, load 8½ x 14-inch-wide paper into the printer, because the self test uses the full 14-inch measure to print out the characters. Align the left edge of the paper with the first black mark on the paper bail-this will ensure that the self test stays on the paper and doesn’t run onto the platen.

Note

If you’ve already loaded narrower paper, such as 8½ x 11, then you should replace it with wider 14-inch paper before running the self test. For information on loading single-sheet paper, see Appendix B.

With the power OFF, hold down the DRAFT button while you turn the power switch ON-the self test takes over and the FX-286 starts printing out the full character set in draft mode (see Figure 1-20).

The self test continues until you shut the power OFF or the paper- out sensor is triggered. To print the self test in the NLQ mode, press the NLQ button when you switch the power ON (see Figure 1-20). To perform the self test in the IBM Proprinter mode see Appendix A.

1-21