3.Release thesprockets by pulling the sprocket lock levers forward.
4.Slide the left sprocket
approximately | Edge guides |
| |
0.5 inch (12 mm) |
|
from the far left |
|
position and push |
|
the lever back to |
|
lock it in place. |
|
Then slide the right sprocket to match the width of your paper, but do not lock it.
Slide the edge guides to the center.5.Make sure your paper has a clean, straight edge. Then open the sprocket covers.
Note:
Make sure the printer is off before you insert the paper in the paper slot. If you insert the paper while the printer is on, a paper jam may occur.
Paper Handling | 23 |