1.Make sure the printer is turned on.

2.Load paper. (If the tractor is in a push position, press the Load/Eject button to advance continuous paper to the current top-of-form position.) If necessary, lift up the printer cover so you can see the paper position.

3.Hold down the Pause button for three seconds. The Pause light flashes and the printer enters the Micro Adjust mode.

4.Press the LF/FF D button to move

the top-of-form position up on the page, or press the Load/Eject U button to move the top-of-form position down on the page.

5.Press the Pause button to exit the Micro Adjust mode.

Note:

❏The printer has a minimum and a maximum top-of-form position. If you try to adjust it beyond these limits, the printer beeps and stops moving the paper.

❏When the paper reaches the default top-of-form position, the printer beeps and stops moving the paper briefly. You can use this setting as a reference point when adjusting the position.

❏The top margin setting made in some software overrides the top-of-form position setting you make with the Micro Adjust function.

Paper Handling

33