Epson LX-1170 manual Adjusting the top-of-form position, c Caution

If you want to change the position where printing begins on the page, press LF/FF to advance the page to the next top-of-form position, and then see Adjusting the top-of-form position in the next section to adjust the loading position.

To eject the paper, tear off the paper entering the printer; then press the LF/FF button to feed the paper forward.

Adjusting the top-of-form position

The top-of-form position is the position on the page where the printer starts printing. If your printing appears too high or low on the page, you can use the micro adjust feature to adjust the top-of-form position. Follow these steps:

cCaution:

Never use the paper-feed knob to adjust the top-of-form position; this may damage the printer or cause it to lose the top-of-form position.

Note:

❏Your top-of-form position setting remains in effect until you change it, even if you turn off the printer.

❏The top margin setting made in some application software overrides the top-of-form position setting you make with the Micro Adjust feature. If necessary, adjust the top-of-form position in your software.

1.Make sure the printer is turned on.

2.If necessary, load paper as described in this chapter.

3.Remove the printer cover.

4.Hold down the Pause button for about three seconds. The Pause light starts flashing and the printer enters the Micro Adjust mode.

35