Epson LX-1170 manual c Caution, Follow these steps to perform a self test

cCaution:

For LX-300+: You should use paper at least 210mm (8 1/4 inches) wide to run the self test; otherwise, the print head prints directly on the platen.

For LX-1170: You should use paper at least 376mm (14.8 inches) wide to run the self test; otherwise, the print head prints directly on the platen.

Follow these steps to perform a self test:

1.When using continuous paper, make sure paper is loaded, and the paper release lever is set to the correct position. Then turn off the printer.

c Caution:

Whenever you turn off the printer, wait at least five seconds before turning it back on; otherwise you may damage the printer.

2.To run the test, turn on the printer while holding down the LF/FF button.

3.When using single-sheet paper, load paper in the printer.

After a few seconds, the printer loads the paper automatically and begins printing the self test. A series of characters is printed.

Note:

To temporarily stop the self test, press the Pause button. To resume the test, press the Pause button again.

4.To end the self test, press the Pause button to stop printing. If paper remains in the printer, press the LF/FF button to eject the printed page. Then turn off the printer.

1

1

1

1

1

1

1

1

1

1

1

1

Troubleshooting 101