Table 2-2.Mode combinations

I

I

/

I

I

I

J

To combine modes you simply select and set more than one mode before you press the LF button to leave SelecType. After beginning the procedure in the normal way and pressing the ON LINE button to select a function and the FF button to set it, you do not press the LF button. Instead, you press the ON LINE button the required number of times to select another mode and set that mode with the

FFbutton. When you have selected and set all the modes you want, press the LF button to leave SelecType.

Don’t worry about harming your printer if you try to combine two modes that the LX-80 can’t mix. Your settings cannot damage the printer because it is prepared for the possibility of receiving codes for conflicting modes. If it receives codes for two modes that it can’t combine, it uses only one of the codes.

The essential element in combining modes is keeping a correct count of the number of times you press the ON LINE button. You do not start counting again after you press the FF button the first time. Instead, you continue the count. Therefore, pressing the ON LINE button three times, then the FF button, then the ON LINE button two more times and the FF button again gives you a combination of double-strike and elite. The first pressings of the ON LINE button select double-strike and the next two give a total of five, which is the number for elite. The number of times you press ON LINE is

cumulative.

For another example, follow these steps to combine NLQ with emphasized for a crisp, bold effect:

1)See that the ON LINE and READY lights are on. Then press the ON LINE and FF buttons at the same time.

21