Epson RX700 Printing from Film, Loading and Setting Film on the Document Table, Printing from Film, 2.Remove the reflective document mat gently along the document cover

Printing from Film

Loading and Setting Film on the Document Table

cCaution:

Hold the film at its edges, or else use gloves. Touching the film surface with bare hands can leave fingerprints or other traces on the film.

Note:

Wipe the inside of the document cover and the document table before scanning transparencies.

1.Make sure the document cover’s cable is connected to the TPU interface connector and open the document cover.

2.Remove the reflective document mat gently along the document cover.

3.Load the transparency into the film holder and position it on the document table. Follow the instructions below as appropriate to your film.

35 mm film strips

1 Open the film cover.

2Set the film into the film holder, flush with the edge and with the front side down. the front side of the film is the side where the film maker's name and film ID numbers can be read correctly.

Top

Bottom

3 Close the film cover.

4Place the film holder on the document table with the side where the film is placed facing toward you.

English

Printing from Film 31