Assigning a Name to the Printer
After you install the LocalTalk interface board and install the driver as described in Chapter 1, you must assign a name to your printer before you can select it in the Chooser.
To assign a name to your printer:
1.
If you installed the EPSON Namer in Chapter 1, look on your hard disk for the icon.
If you did not install the EPSON Namer, insert the EPSON Macintosh driver diskette into a diskette drive.
2.Under Device Types, select the
3.If there are multiple AppleTalk zones at your site, select the zone in which your printer is located.
4.Under New Name, enter a name for your printer.
5.Choose Rename. Then choose Done to exit the EPSON Namer.
Turning on the Printer’s Network Mode
If you encounter problems when using the printer on an AppleTalk network, you may need to turn on the printer’s network mode by using the buttons on the control panel. To turn on the network interface mode:
1.Make sure the printer is off and that paper is loaded in the input tray.
2.While holding down the Economy/Condensed button, turn on the printer.