Connecting the Drawer | Epson TM-T88II specification

2.If the printer has a serial interface, tighten the screws on both sides of the cable connector.

Note:

Your printer has inch-type hexagonal lock screws installed. If your interface cable requires millimeter-type screws, replace the inch-type screws with the enclosed millimeter-type screws using a hex screwdriver (5 mm).

Inch screw

Millimeter screw

If the printer has a parallel interface, squeeze the wire clips on the printer together until they lock in place on both sides of the connector.

3. Attach the other end of the cable to the computer.

Connecting the Drawer

WARNING:

Use a drawer that matches the printer specifications. Using an improper drawer may damage the drawer as well as the printer.

Setting Up the Printer 1-3

Image 17

Epson TM-T88II user manual Connecting the Drawer

Contents

TM-T88II Series Labels Printer Parts and Labels Installing and Replacing Paper Setting Up the PrinterSolving Problems Quick ReferencePage Iii EMC and Safety Standards AppliedProduct Name TM-T88II Model Name M129B For American Users CE MarkingFCC Compliance Statement Gereäuschpegel Reference Setting Up and UsingAbout This Manual Introduction FeaturesPrinting Application Software Viii Introduction Options and Accessories Specified Thermal Roll Paper NTP080-80 Ordering Paper and Supplies Kanzaki Specialty Papers, Inc Other Qualified Suppliers for Thermal PaperJujo Thermal Oy Finland Contents Xii Appendix a DIP Switch and Paper Near End Settings Unpacking Setting Up the PrinterSetting Up the Printer 2Setting Up the Printer Connecting the Cables and Grounding the PrinterConnecting the computer Connecting the Drawer Anschließen der Schublade 4Setting Up the Printer Grounding the Printer Connecting the Power SupplyPage Installing or Replacing the Paper Roll 8Setting Up the Printer Tear off the paper as shown 10Setting Up the Printer Using the Power Switch CoverSelf Test Running the self test Self test printing Please press the Paper Feed button 12Setting Up the Printer Adjustments and Settings Using the Printer Using the PrinterOperating the Control Panel Control Panel Panel lights 2Using the Printer Troubleshooting TroubleshootingGeneral problems Printing problems Printing is poor Error light is off, but nothing is printed2Troubleshooting Paper is jammed inside the printer Cleaning the print headPaper handling problems 4Troubleshooting Auto cutter is jammed Auto cutter problems 6Troubleshooting Abcdefgh Hexadecimal Dump 8Troubleshooting Reference Information Printing SpecificationsReference Information 2Reference Information Line spacing default 4.23 mm 1/6 Paper roll single-ply Size Paper Specifications Consumption at Electrical CharacteristicsCurrent Reliability TemperatureEnvironmental Conditions Life 6Reference Information Setting the DIP Switches DIP Switch and Paper Near End SettingsDIP switch functions Serial interface specifications 2DIP Switch and Paper Near End Settings Print Density Selection DIP Switch and Paper Near End Settings A-3 4DIP Switch and Paper Near End Settings Parallel interface specifications DIP Switch and Paper Near End Settings A-5 6DIP Switch and Paper Near End Settings Changing the DIP switch settings DIP Switch and Paper Near End Settings A-7 Adjusting the Paper Near End Detector 8DIP Switch and Paper Near End Settings Page 1999.12