DIP Switch and Paper Near End Settings A-3 | Epson TM-T88II manual

Print Density Selection

Print Density		SW 2-3	SW 2-4

1 Low power consumption mode		ON	ON

2	(Normal)	OFF	OFF

3		ON	OFF

4	(Dark)	OFF	ON

Notes:

•With the optional RS-485 interface, DIP switches 2-7 and 2-8 are disabled.

•Changes in DIP switch settings (excluding switches 2-7 and 2-8 interface reset signals) are recognized only when the printer power is turned on or when the printer is reset by using the interface. If the DIP switch setting is changed after the printer power is turned on, the change does not take effect until the printer is turned on again or is reset.

•If you turn on DIP switch 2-7 or 2-8 while the printer is turned on, the printer may be reset, depending on the signal state. DIP switches should not be changed while the printer power is on.

•If the print density is set to level 3 or 4, the printing will be at low speed.

•In a low power consuption, printing speed is fixed to 70 mm/sec.

DIP Switch and Paper Near End Settings A-3

Image 45

Epson TM-T88II user manual DIP Switch and Paper Near End Settings A-3, Print Density Selection

Contents

TM-T88II Series Labels Printer Parts and Labels Installing and Replacing Paper Setting Up the PrinterSolving Problems Quick ReferencePage EMC and Safety Standards Applied Product Name TM-T88II Model Name M129BIii CE Marking FCC Compliance StatementFor American Users Gereäuschpegel Setting Up and Using About This ManualReference Introduction FeaturesPrinting Application Software Viii Introduction Options and Accessories Specified Thermal Roll Paper NTP080-80 Ordering Paper and Supplies Other Qualified Suppliers for Thermal Paper Jujo Thermal Oy FinlandKanzaki Specialty Papers, Inc Contents Xii Appendix a DIP Switch and Paper Near End Settings Setting Up the Printer Setting Up the PrinterUnpacking Connecting the Cables and Grounding the Printer Connecting the computer2Setting Up the Printer Connecting the Drawer Anschließen der Schublade 4Setting Up the Printer Grounding the Printer Connecting the Power SupplyPage Installing or Replacing the Paper Roll 8Setting Up the Printer Tear off the paper as shown 10Setting Up the Printer Using the Power Switch CoverSelf Test Running the self test Self test printing Please press the Paper Feed button 12Setting Up the Printer Adjustments and Settings Using the Printer Using the PrinterOperating the Control Panel Control Panel Panel lights 2Using the Printer Troubleshooting TroubleshootingGeneral problems Printing problems Error light is off, but nothing is printed 2TroubleshootingPrinting is poor Cleaning the print head Paper handling problemsPaper is jammed inside the printer 4Troubleshooting Auto cutter is jammed Auto cutter problems 6Troubleshooting Abcdefgh Hexadecimal Dump 8Troubleshooting Printing Specifications Reference InformationReference Information 2Reference Information Line spacing default 4.23 mm 1/6 Paper roll single-ply Size Paper Specifications Electrical Characteristics CurrentConsumption at Reliability TemperatureEnvironmental Conditions Life 6Reference Information Setting the DIP Switches DIP Switch and Paper Near End SettingsDIP switch functions Serial interface specifications 2DIP Switch and Paper Near End Settings Print Density Selection DIP Switch and Paper Near End Settings A-3 4DIP Switch and Paper Near End Settings Parallel interface specifications DIP Switch and Paper Near End Settings A-5 6DIP Switch and Paper Near End Settings Changing the DIP switch settings DIP Switch and Paper Near End Settings A-7 Adjusting the Paper Near End Detector 8DIP Switch and Paper Near End Settings Page 1999.12