Epson TM-T88II Series specs

WARNING:

Make sure you use the EPSON PS-170 power supply or equivalent. Using an incorrect power supply may cause fire or electrical shock.

CAUTION:

When connecting or disconnecting the power supply from the printer, make sure the power supply is not plugged into an electrical outlet. Otherwise you may damage the power supply or the printer.

If the power supply’s rated voltage and your outlet’s voltage do not match, contact your dealer for assistance. Do not plug in the power cord. Otherwise, you may damage the power supply or the printer.

1.Make sure the printer’s power switch is turned off, and the power supply’s power cord is unplugged from the electrical outlet.

2.Check the label on the power supply to make sure the voltage required by the power supply matches your electrical outlet.

3.Plug in the power supply’s cable as shown below. Notice that the flat side of the plug faces down.

Note:

To remove the DC cable connector, make sure the power supply’s power cord is unplugged; then grasp the connector at the arrow and pull it straight out.

1-6Setting Up the Printer

Image 18

Epson TM-T88II Series user manual

Contents

TM-T88II Series Thermal head is hot La téte thermique est chaude Printer Parts and LabelsLabels Der Thermalkopf ist heiß Installing and Replacing Paper Solving ProblemsQuick Reference Page EMC and Safety Standards Applied Product Name TM-T88II Model Name M129BIii CE Marking FCC Compliance StatementFor American Users Gereäuschpegel Setting Up and Using About This ManualReference Printing FeaturesIntroduction Application Software Options and Accessories Viii Introduction Contents Appendix a DIP Switch and Paper Near End Settings Setting Up the Printer Setting Up the PrinterUnpacking Connecting the Cables and Grounding the Printer Connecting the computer2Setting Up the Printer Connecting the Drawer 4Setting Up the Printer Anschließen der Schublade Connecting the Power Supply Grounding the PrinterPage Installing or Replacing the Paper Roll 8Setting Up the Printer Tear off the paper as shown Self Test Using the Power Switch Cover10Setting Up the Printer Running the self test Self test printing Please press the Paper Feed button Adjustments and Settings 12Setting Up the Printer Operating the Control Panel Using the PrinterUsing the Printer Control Panel 2Using the Printer Panel lights General problems TroubleshootingTroubleshooting Printing problems Error light is off, but nothing is printed 2TroubleshootingPrinting is poor Cleaning the print head Paper handling problemsPaper is jammed inside the printer 4Troubleshooting Auto cutter problems Auto cutter is jammed 6Troubleshooting Hexadecimal Dump 8Troubleshooting Printing Specifications Reference InformationReference Information Line spacing default 4.23 mm 1/6 2Reference Information Paper Specifications Paper rollSingle-ply Electrical Characteristics CurrentConsumption at Environmental Conditions TemperatureReliability Life 6Reference Information DIP switch functions DIP Switch and Paper Near End SettingsSetting the DIP Switches Serial interface specifications 2DIP Switch and Paper Near End Settings DIP Switch and Paper Near End Settings A-3 Print Density Selection Parallel interface specifications 4DIP Switch and Paper Near End Settings DIP Switch and Paper Near End Settings A-5 Changing the DIP switch settings 6DIP Switch and Paper Near End Settings Adjusting the Paper Near End Detector DIP Switch and Paper Near End Settings A-7 1999.12