Correcting Color for Multiple Projectors (Multi-Screen Color Adjustment) 58
Correcting Color for Multiple Projectors (Multi-Screen Color Adjustment)
When multiple projectors are lined up and projecting images, you can
manually correct the brightness and color tone of each projector's image
so that the colors projected from each projector match closely.
Set each projector to the same Color Mode before using the multi-screen
color adjustment function.
In some cases the brightness and color tone may not match completely
even after correction.
Auto Iris does not work while this function is activated. Even if Auto Iris
is set to On, and Multi-screen is set to On, Auto Iris does not work.
Summary of Correction Procedure
When multiple projectors are set up and you need to make corrections,
use the following procedure to correct one projector at a time.
Correction Method
After setting up the projectors, correct the brightness and tone for each
projector to reduce the differences.
Procedure
APress the [Menu] button and select Extended -
"Multi-screen" from the configuration menu.
BSet "Multi-screen" to "On".
CSelect Lv. to be corrected in Adjustment Level.
•Each time a level is selected, the pattern of the level selected is dis-
played.
•You can start correcting from any level, usually you can make it
darker or lighter by correcting 1 to 5 or 5 to 1.
DCorrect the brightness with Brightness Correct.
•When you select Lv. 5, all the images are adjusted to the darkest
image from multiple projectors.
•When you select Lv. 1, all the images are adjusted to the brightest
image from multiple projectors.
•When you select Lv. 2 to 4, all the images are adjusted to the
mid-range brightness image from multiple projectors.
•Because each time the [Enter] button is pressed the image dis-
played changes between the pattern display and the actual image,
you can check the correction results and make corrections in the
actual image.
1. Set the projector ID and the remote control ID.
To limit operation to one target projector, set a Projector ID for the
target projector, and set the same ID for the remote control. sp.55
2. Correct the color difference.
You can carry out color correction when projecting from multiple
projec tors. You c an adj ust fr om bl ack to whit e in fi ve st ages c alle d leve ls
1 to 5, and in each of these 5 levels you can adjust the following two
points.
•Correcting brightness
You can correct the image brightness to make them all equal.
•Correcting color
You can adjust the image color to make them match more closely by
using Color Correct. (G/R) and Color Correct. (B/Y).