List of Functions 74
Operation Direct Power On: You can set whether or not (On/Off) to enable Direct Power On.
Be careful when this item is set to On because this unit turns on at the time of power recovery with this unit plugged-in to an outlet.
Sleep Mode: When set to On, this automatically stops projection when no image signal is being input and no operations are carried
out.
Sleep Mode Timer: When Sleep Mode is set to On, you can set the time before the projector automatically turns off within a range
of 1 to 30 minutes.
Shutter Timer: When set to On, this turns off the power automatically 120 minutes after the electric shutter is closed. Shutter
Timer is set to On at the time of purchase. (When Shutter Time and Sleep Mode are set to On at the same time, Sleep Mode has
priority.)
High Altitude Mode: Set to On when using the projector above an altitude of 4900 ft (1500 m).
BNC Sync Termination: Set the termination for the signal from the BNC input port. This should usual ly be set to Off. Set to On when
analog (75Ω) termination such as for switchers is necessary.
Remote Control Type: You can select Normal or Simple depending on the type of remote control.
Set this item to Normal to use the remote control provided with the projector. When Simple is selected, you can use the remote
control provided with other Epson projectors to operate this projector. This is useful if you want to use a re mote control that you
are already familiar with to operate the projector.
However, you cannot use the remote control provided with the projector if this is set to Simple. Make sur e you w ant to chan ge thi s
setting to Simple because, if the projector is mounted on the ceiling or somewhere hard to reach, changing it back may be difficult.
Standby Mode You can use the functions that monitor and control the status of the projector over the network even when the projector is in
standby mode if this is set to Communication On.
You can use SNMP to monitor and control the status of the projector over the network, or by using the EasyMP Monitor software
supplied with this product.
Air Filter Notice You can set whether or not (On/Off) to enable the Air Filter Notice. When this is set to On and a clog in the air filter is detected, the
message is displayed on the screen.
Projector ID Set the ID within a range of 1 to 9. Off indicates that no ID is set. sp.56
Sub Menu Function