Remote Mount Installation
The bracket shown in Figure 27 is used for Remote Mounting (USA Only). In some applications the bracket shown in Figure 26 can also be used for Remote Mounting. The following instructions are for a Remote Mount installation using the bracket shown in Figure 27.
1.Using the bracket as a template, mark and drill the mounting holes using a No. 27 drill. Be sure to leave enough room at the rear of the radio unit for the cable connections.
2.Secure the Mounting bracket using four
screws (use
3.Slide the radio unit into the bracket by aligning bracket guides with grooves on each side of radio (rear of radio should be inserted first). Slide radio back until screw holes in front of bracket align with screw holes in side of radio. See Figure 27.
4.Secure radio to the bracket with two M4 x 10 mm socket head screws provided.
5.Connect antenna coaxial cable to antenna connector (TNC).
6.Connect remote control cable connector P1 to the ORCC connector on the radio unit and secure with the two captive screws.
7.Connect other end of remote control cable to the remote control cable connector (RCCC) on the remote control unit.
8.Connect remote mount accessory cable connector P1 to the option connector (OPT) on control unit. Then connect the speaker to connector P2 and accessory connector P3 to any options (hookswitch, etc.). If connector P3 is not used, insulate and tie back to main cable.
9.Recheck all connections and cables. Insert fuse into transmit fuse assembly.
29
